Table of Contents
1.1 Replacement Parts
1.2 General Information
1.3 Technical Specifications & Required Tools
1.4 Door Handings
1.5 Consideration of Surroundings
1.6 Electrical
2.1 Pre-Mounting Header Box Instructions
2.2 Operator Layout and Handing - Push and Pull
2.3 Handing Modification - Left to Right (and vice versa)
2.4 Double Egress Header
2.5 Control Board and Gearbox Installation
2.6 Connect Motor Wire Leads
3.1 Arm Components and Configurations
3.2 Push Arm Installation
3.3 Pull Arm (Z-arm) Installation
3.4 Universal Arm Installation
4.1 Back Check and Latch Adjustment
4.2 Spring Tension Adjustment
6.1 Basic Operation
6.2 Operation Switch
7.1 Digital Board Diagram
7.2 Digital Board Wiring Diagram
7.3 Digital Board Specification
8.1 Programming Specification (Digital Board)
8.2 Safety Monitoring
8.3 Safety Sensor Connection - BEA Bodyguard
8.4 Safety Sensor Connection - BEA Superscan
8.5 Safety Sensor Connection - Optex OA-FLEX
9.1 Dual Door Digital Board Specification
(Fully Automatic only)
9.2 Wiring Diagram
9.3 Programming Specification
12.1 Additional Components:
Sensor(s) / Knowing Act Devices
12.2 Header Cover Installation
12.3 Safety Decals
To Next Page
Loading...
