dixell iCHiLL IC200CX Series User Manual

33.10 END DEFROST BY LOW WATER OUTLET EVAPORATOR TEMPERATURE 55
33.11 DEFROST PARAMETER DESCRIPTION 55
34 ENERGY SAVING 57
34.1 ENERGY SAVING: DIGITAL INPUT ACTIVATION 57
34.2 ENERGY SAVING TIME TABLE WITH RTC 57
34.3 RTC DAILY TIME TABLE PROGRAMMING 57
34.4 ENERGY SAVING OR UNIT ON/OFF ACTIVATION WITH RTC PROGRAMMING 57
34.5 UNIT ON/OFF ACTIVATION WITH RTC PROGRAMMING AND DIGITAL INPUT 58
35 DYNAMIC SETPOINT 59
35.1 DYNAMIC SETPOINT GRAPH 59
36 GEOTHERMAL FUNCTION 60
37 AUXILIARY FUNCTION 61
37.1 AUXILIARY FUNCTION ON RELAY OUTPUT 61
37.1.1 Auxiliary relay on Direct action .....................................................................................................................................61
37.1.2 Auxiliary relay on reverse action...................................................................................................................................62
37.2 AUXILIARY FUNCTION ON ANALOG OUTPUTS 62
38 LOAD MAINTENANCE 63
38.1 LOAD MAINTENANCE RESQUESTS 63
39 MESSAGES - ALARM CODES 64
39.1 AP1 - AP2 - AP3 - AP4 - AP5 - AP6 - AP7 - AP8 PROBE FAILURE 64
39.2 AEFL: EVAPORATOR FLOW ALARM (DIFFERENTIAL PRESSURE SWITCH) 64
39.3 ACFL: CONDENSER FLOW ALARM (DIFFERENTIAL PRESSURE SWITCH) 64
39.4 ATSF: OVERLOAD ALARM OF THE SUPPLY FAN 65
39.5 ATE1 - ATE2 EVAPORATOR PUMP OVERLOAD ALARM 65
39.6 ATC1 - ATC2 CONDENSER PUMP OVERLOAD ALARM 65
39.7 AEE EEPROM ALARM 65
39.8 AFR: POWER SUPPLY FREQUENCY ALARM 66
39.9 ALC1: GENERIC ALARM WITH STOP REGULATION 66
39.10 ALC2: GENERIC SIGNAL ALARM 66
39.11 ALC2: GENERIC ALARM WITH STOP REGULATION 66
39.12 ACF1 - ACF2 - ACF3 - ACF4 - ACF5 - ACF6 - ACF7 - ACF8 - ACF9 – ACF10 – ACF11 CONFIGURATION ALARM
OF THE UNIT 67
39.13 ARTF CLOCK FAILURE 69
39.14 ARTC CLOCK ALARM 69
39.15 AEUN: UNLOADING FROM HIGH TEMPERATURE OF THE EVAPORATOR WATER INLET 69
39.16 AEHT: ALARM FROM HIGH TEMPERATURE OF THE EVAPORATOR WATER INLET 69
39.17 AELT LOW WATER TEMPERATURE INLET (ONLY HEAT PUMP) 69
39.18 AEDT DIFFERENTIAL ALARM EVAPORATOR WATER INLET – OUTLET TEMPERATURE 70
39.19 ALTI: LOW AIR AMBIENT TEMPERATURE (AIR / AIR UNIT ONLY) 70
39.20 AEP1 - AEP2 EVAPORATOR PUMPS / SUPPLY FAN MAINTENANCE REQUEST 71
39.21 ACP1 - ACP12 CONDENSER PUMPS MAINTENANCE REQUEST 71
39.22 B1HP - B2HP HIGH PRESSURE SWITCH CIRCUIT 1 AND 2 71
39.23 B1LP - B2LP LOW TEMPERATURE / LOW CONDENSING PRESSURE OF THE CIRCUIT 72
39.24 B1AC - B2AC - B1AC - B2AC ANTIFREEZE ALARM / LOW OUTLET TEMPERATURE (AIR / AIR UNIT IN CHILLER
MODE) 72
39.25 B1AH - B2AH ANTI-FREEZE ALARM / LOW OUTLET AIR TEMPERAURE(AIR/AIR UNIT ONLY) ON HEAT PUMP
MODE 72
39.26 B1HP - B2HP HIGH CONDENSING PRESSURE / TEMPERATURE OF THE CIRCUIT 73
39.27 B1LP - B2LP LOW PRESSURE SWITCH CIRCUIT #1 OR 2 73
39.28 B1LP - B2LP LOW EVAPORATING PRESSURE OF THE CIRCUIT (WITH PRESSURE TRANSDUCERS ONLY) 73
39.29 B1TF- B2TF CONDENSER FAN OVERLOAD ALARM 73
39.30 B1EU – B2EU: UNLOADING FROM LOW TEMPERATURE OF THE EVAPORATOR WATER OUTLET 74
39.31 C1HP - C2HP COMPRESSOR HIGH PRESSURE ALARMS 74
39.32 C1OP - C2OP PRESSURE SWITCH ALARM / COMPRESSOR OIL 74
39.33 C1DT - C2DT HIGH COMPRESSOR DISCHARGE TEMPERATURE ALARM 74
39.34 C1TR - C2TR COMPRESSOR OVERLOAD ALARM 75
39.35 B1DF – B2DF DEFROST ALARM 75
39.36 B1CU – B2CU UNLOADING: HIGH CONDENSING TEMPERATURE / PRESSURE IN CHILLER 75
39.37 B1CU – B2CU: UNLOADING: LOW CONDENSING TEMPERATURE / PRESSURE IN HEAT PUMP 75
39.38 B1PH - B2PH: PUMP DOWN STOP ALARM FROM PRESSURE SWITCH / LOW PRESSURE SWITCH 76
39.39 B1PL - B2PL ALARM DURING THE PUMP DOWN START-UP FROM PUMP DOWN PRESSURE SWITCH / LOW
PRESSURE TRANSDUCER 76
39.40 C1MN - C2MN COMPRESSOR MAINTENANCE 76
39.41 ALARM RELAY AND BUZZER 77

dixell iCHiLL IC200CX Series Specifications

General

Brand	dixell
Model	iCHiLL IC200CX Series
Category	Temperature Controller
Language	English