DJI FPV
User Manual
26
© 2021 DJI All Rights Reserved.
The battery level LEDs display the power level of the ight battery during charging and discharging. The
statuses of the LEDs are dened below:
LED is on. LED is ashing. LED is o.
LED1 LED2 LED3 LED4 Battery Level
Battery Level > 88%
75% < Battery Level ≤ 88%
63% < Battery Level ≤ 75%
50% < Battery Level ≤ 63%
38% < Battery Level ≤ 50%
25% < Battery Level ≤ 38%
13% < Battery Level ≤ 25%
0% < Battery Level ≤ 13%
Powering On/O
Press the power button once and then press again and hold for two seconds to power the battery on or o. The
battery level LEDs display the battery level when the aircraft is powered on.
Low Temperature Notice
1. Battery capacity is signicantly reduced when ying in low-temperature environments of 14° to 41° F (-10° to 5°
C). It is recommended to hover the aircraft in place for a while to heat the battery. Make sure to fully charge the
battery before takeo.
2. Batteries cannot be used in extremely low-temperature environments lower than 14° F (-10° C).
3. When in low-temperature environments, end the ight as soon as the goggles display the low battery voltage
warning.
4. To ensure optimal performance, keep the battery temperature above 68° F (20° C).
5. The reduced battery capacity in low-temperature environments reduces the wind speed resistance
performance of the aircraft. Fly with caution.
6. Exercise extra caution when ying high above sea level.
In cold environments, insert the battery into the battery compartment and power on the aircraft to warm
up before taking o.
Charging the Battery
Use the provided DJI charger to fully charge the Intelligent Flight Battery before every ight.
1. Connect the AC power adapter to an AC power supply (100-240 V, 50/60 Hz).
2. Attach the Intelligent Flight Battery to the AC power adapter using the battery charging cable with the battery
powered o.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
