To Next Page

To Previous Page

Aircraft

Mavic Pro

User Manual

Using the Battery

The Battery Level Indicators will also show the current battery level during charging and

discharging. The indicators are dened below.

: LED is on. : LED is ashing.

: LED is off.

7. Over Current Protection: The battery stops charging when high amperage (more than 8.5 A) is

detected.

8. Over Discharge Protection: To prevent over-discharge damage, discharging automatically stops.

9. Short Circuit Protection: Automatically cuts the power supply when a short circuit is detected.

10. Battery Cell Damage Protection: The DJI GO app displays a warning message when a damaged

battery cell is detected.

11. Sleep Mode: To save power, the battery will cut off power supply and enters sleep mode after 20

minutes of inactivity.

12. Communication: Information pertaining to the battery’s voltage, capacity, current, etc. is transmitted to

the aircraft’s main controller.

Refer to

Mavic Pro Intelligent Flight Battery Safety Guidelines

before use. Users take full

responsibility for all operations and usage.

LED2

LED1

LED3

LED4

Battery Level Indicators

Power Button (Built-in LED)

Turning ON/OFF

Turning On:

Press the Power Button once, then press again and hold for 2 seconds to turn on. The Power

LED will turn red and the remote controller system status screen will display the current

battery level.

Turning Off:

Press the Power Button once, then press again and hold for 2 seconds to turn off. The battery

power LED will ash when powering off the aircraft to allow for video recording to be stopped,

if the recording was not stopped prior to powering off.

dji mavic User Manual

Other manuals for dji mavic