dji mavic - Smart & Low Battery RTH

Aircraft
14
©
2016 DJI. All Rights Reserved.
Mavic Pro User Manual
Battery Level
Warning
Remark
Aircraft Status
Indicator
DJI GO App Flight Instructions
Low battery
level warning
The battery
power is low.
Please land the
aircraft.
Aircraft status
indicator blinks
RED slowly.
Tap “Go-home” to have the
aircraft return to the Home
point and land automatically,
or “Cancel” to resume normal
flight. If no action is taken,
the aircraft will automatically
go home and land after 10
seconds. Remote controller
will sound an alarm.
Fly the aircraft
back and land
it as soon as
possible, then
stop the motors
and replace the
battery.
Low Battery RTH
The low battery level failsafe is triggered when the DJI Intelligent Flight Battery is depleted to a point that
may affect the safe return of the aircraft. Users are advised to return home or land the aircraft immediately
when prompted. The DJI GO app will display a notice when a low battery warning is triggered. The
aircraft will automatically return to the Home Point if no action is taken after a ten-second countdown. The
user can cancel the RTH procedure by pressing the RTH button on the remote controller. The thresholds
for these warnings are automatically determined based on the aircraft’s current altitude and distance from
the Home Point.
The aircraft will land automatically if the current battery level can only support the aircraft long enough
to descend from its current altitude. The user can still use the remote controller to alter the aircraft’s
orientation during the landing process.
The Battery Level Indicator is displayed in the DJI GO app, and is described below:
Battery level Indicator
Critical Low battery level
warning(Red)
Low battery
level warning(Yellow)
Sufcient battery
level(Green)
Remaining ight time
Power requires
to return home
12:29
Smart RTH
Use the RTH button on the remote controller (refer to “RTH button” on page 34 for more information) or
tap the RTH button in the DJI GO app and follow the on-screen instructions when GPS is available to
initiate Smart RTH. The aircraft status indicator blinks to display the current status. The aircraft will sense
and avoid obstacles on its ight path during Smarth RTH. The aircraft may chose to navigate or hover in
place to avoid collision. User can manually navigate the aircraft to avoid obstacles if the Forward Vision
System is disabled when light condition is not ideal. In addition, user can also immediately exit from Smart
RTH by using the Pause button on the remote controller or press the Stop icon on the DJI GO app.