Remote Controller
36
©
2016 DJI. All Rights Reserved.
Mavic Pro
User Manual
RC Control Setting
RC Calibration
Stick Mode
Button Customization
Not DefinedC1
C2 Not Defined
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back of the RC.
Linking RC
Linking the Remote Controller
The remote controller is linked to your aircraft before delivery. Linking is only required when using a new
remote controller for the rst time. Follow these steps to link a new remote controller:
1. Turn on the remote controller and connect to the mobile device. Launch the DJI GO app.
2. Turn on the Intelligent Flight Battery.
3. Enter “Camera” and tap on and then tap “Linking RC” button as shown below.
Flight speed
Aircraft battery level GPS signal strength RC signal strength
Motor rotation
speed
System status prompt
RC battery level
Distance to the ground
Vision System
Camera status
Flight altitude
Exposure compensation
Flight distance
Sport modes
Micro SD
placement
Toggle the Control Mode switch to RC mode before linking.
To Next Page
Loading...
Need help?
General