DJI Mini 3
User Manual
21
©
2022 DJI All Rights Reserved.
Attaching the Propellers
Attach the propellers with marks to the motors of the arm with marks and the unmarked
propellers to the motors of the arm without marks. Use the screwdriver from the aircraft
package to mount the propellers. Make sure the propellers are secure.
Marked Unmarked
•
Make sure to only use the screwdriver from the aircraft package for mounting
propellers. Using other screwdrivers may damage the screws.
•
Make sure to keep the screws vertical while tightening them. The screws should not be
at a tilted angle to the mounting surface. After installation is complete, check whether
the screws are flush and rotate the propellers to check for any abnormal resistance.
Detaching the Propellers
User the screwdriver from the aircraft package to loosen the screws and detach the propellers
from the motors.
•
Propeller blades are sharp. Handle with care.
•
The screwdriver is only for mounting the propellers. DO NOT use the screwdriver to
disassemble the aircraft.
•
If a propeller is broken, remove the two propellers and screws on the corresponding
motor and discard them. Use two propellers from the same package. DO NOT mix
with propellers from other packages.
•
Only use official DJI propellers. DO NOT mix propeller types.
•
Purchase additional propellers if necessary.
•
Make sure that the propellers and motors are installed securely before each flight.
Check to make sure the screws on the propellers are tightened after every 30 hours of
flying time (approx. 60 flights).
•
Make sure all propellers are in good condition before each flight. DO NOT use aged,
chipped, or broken propellers.
•
To avoid injury, stand clear of and do not touch propellers or motors when they are spinning.
•
DO NOT squeeze or bend the propellers during transportation or storage.
•
Make sure the motors are mounted securely and rotating smoothly. Land the aircraft
immediately if a motor is stuck and unable to rotate freely.
•
DO NOT attempt to modify the structure of the motors.
•
DO NOT touch or let hands or body parts come in contact with the motors after flight
as they may be hot.
•
DO NOT block any of the ventilation holes on the motors or the body of the aircraft.
•
Make sure the ESCs sound normal when powered on.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
