5 Maintenance
5.1 Updating Firmware
Use DJI Mimo to update the rmware of the device.
Ensure the battery is fully charged before updating the rmware. Connect the device to
DJI Mimo. If new rmware is available, DJI Mimo will display a prompt. Tap the prompt and
follow the on-screen instructions to update the rmware.
If the update fails, follow the steps for troubleshooting.
1. Restart the camera and DJI Mimo.
2. Enable Wi-Fi and Bluetooth on the mobile device.
3. Connect the camera to DJI Mimo and try the update again.
Contact DJI Support if the update fails again.
5.2 Underwater Usage Notes
The product can be used underwater at depths of up to 20 m. When used with the Osmo
Action 60m waterproof case, the product can be operated underwater up to 60 m deep.
Observe the following precautions before using the product in water.
1. Make sure the battery and battery compartment are dry and clean before inserting
the battery. Otherwise, it may aect the battery contact and waterproong ability.
Make sure the battery compartment cover is rmly fastened after the battery is
inserted. Note that the red marks should not be visible after the cover is properly
fastened.
2. Make sure the USB-C port cover, and lens protective cover are rmly mounted and
fastened, and that the waterproof seal is clean. Otherwise, it will aect the device
waterproong ability. All the holes on the product use a built-in waterproof material.
DO NOT poke the holes.
3. Check if the lens protective cover is in good condition. If damaged, replace it
immediately. Make sure the lens protective cover and lens are dry and clean. Sharp or
hard objects may damage the lens and aect the ability of the camera. Make sure that
the lens protective cover is rmly mounted and the rubber ring at the base of the lens
is not detached.
4. The product is NOT waterproof when used with Osmo Action Lens Hood.
Observe the following precautions when using the product in water.
Osmo Action 5 Pro User Manual
© 2024 DJI All Rights Reserved. 27
To Next Page
Loading...
