EasyManua.ls Logo

DKS 1802-EPD - 3.1.10 Star (*) Key Functionality; 3.1.11 System Stay On-Line or Hang Up; 3.1.12 Automatic Hang-up Function; 3.2 Phone Number Programming

Default Icon
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1802-065-A-8-06
Page 27
3.1.10 Star (*) Key Function
This programming sequence sets the function of the * key on the keypad during conversation. This
key can be set to hang-up the entry system when pressed during conversation, or it can be
programmed to touch-tone out during conversation.
Factory setting = 0 (hang-up).
1. Press *27 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 0* (beep) for hang-up, or press 1* (beep) for touch-tone.
3. Press 0# TOGETHER to end this programming step (beeeeeep).
3.1.11 System to Stay On-Line or Hang Up after Touch Tone
This programming sequence provides a method for the telephone entry system to remain on line after
a resident has pressed the touch tone number to open the door or gate. Each relay can be set
independently to either remain on line or hang up.
Factory setting = 1 (hang up after touch tone) for both relays.
1. Press *28 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press 1* for relay 1 (beep), or press 2* for relay 2 (beep).
3. Press 0* (beep) to keep the system on line, or press 1* (beep) to make it hang up.
4. Repeat steps 2 and 3 to program the other relay.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.1.12 Automatic Hang-up Function
This programming sequence determines when the phone system will automatically hang itself up
after a predetermined time of inactivity. You can program the system to not hang-up (0), to hang-up
after 5 sec of dial-tone (1), to hang-up after 15 sec of silence (2) or to hang-up after either 5 sec of
dial-tone or 15 sec of silence (3). NOTE: This programming function is available on REV G
boards or higher only.
Factory setting = 1 (hang-up after 5 sec of dial-tone).
1. Press *40 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the hang-up code desired _ then press * (beep).
3. Press 0# TOGETHER to end this programming step (beeeeeep).
Code Function
0 No hang-up.
1 Hang-up after 5 sec. of dial-tone (Factory setting).
2 Hang-up after 15 sec. of silence.
3 Hang-up after 5 sec. of dial-tone OR 15 sec. of silence.

Table of Contents

Related product manuals