1802-065-A-8-06
Page 35
3.3.7 Delete a Single Name
This program sequence is useful to delete a single name that has been programmed into the
directory.
1. Press * 65 and enter the four-digit MASTER CODE _ _ _ _ (beep). The display
shows: *=NEXT, 0=ERASE. Press any key to display the first name in the memory.
2. Press * to keep the name or press 0 to erase the name. The next name is displayed.
3. Repeat step 2 to keep skipping or erasing names.
4. Press 0# TOGETHER to end the programming session. When the programming is
ended, the display will read SORTING while the system alphabetizes the names.
This may take a few minutes. A long beep (beeeeeep) will be heard when the sorting
is complete.
3.3.8 Delete ALL Names
This program sequence will delete ALL names that have been programmed into the directory.
Caution: once the deletion process begins (pressing 1* in step 2), it is irreversible.
1. Press * 67 and enter the four-digit MASTER CODE _ _ _ _ (beep). The display
shows: 1=Y 0=N
2. Press 1* to erase all names or press 0* to keep the names.
3. Once you press 1* in step 2, the display will read ERASING. A long beep
(beeeeeep) will be heard when the erasing is complete.
To Next Page
Loading...
