1802-065-A-8-06
Page 40
3.5.5 Flash Entry Codes
This programming sequence sets up "FLASH" four-digit entry codes. Flash codes are entry codes
that will operate on a specific day of the month only - they will not operate before or after the
programmed day. The flash code will be valid for a single 24-hour period only. For example, if you
program a flash code on July 1st to be active on the 10th, the code will become valid at 00:00 AM on
July 10th and expire at 11:59 PM. The code will not be valid on August 10th. You can program up to
eight flash codes in the system. Flash codes 1 through 4 will activate relay 1, flash codes 5 through 8
will activate relay 2.
1. Press *15 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter a flash code number (1 - 8) then press * (beep).
3. Enter the day of the month that the code is to be active _ _ then press * (beep).
4. Enter a four-digit FLASH ENTRY CODE _ _ _ _ then press * (beep).
5. Repeat steps 2 through 4 to enter additional flash codes.
6. Press 0# TOGETHER to end this programming step (beeeeeep).
To Next Page
Loading...
