LUXEPaINTBaLL.COm
866.573.LUXE(5893)
HarDWarE 3.5 LiPo rECHarCHaBLE BaTTErY
YOUR LUXE® IS EQUIPPED WITH a Lithium-Polymer (LiPo) battery. Lithium-Polymer batteries provide
consistent power output in a minimal size and weight, without suffering from charge memory effects.
To charge the Luxe®, use a 5/64-inch allen wrench to remove the four grip screws and completely remove the
grip (avoid folding the grip back from one side as this may cause damage.) Simply plug the included charger
into the marker’s charging port, and plug the adapter into a domestic power outlet. The Luxe® charger is
designed for international use, and will operate on standard mains 50 or 60 Hz AC power from 110 to 240
volts. Plug adapters may be required when using the Luxe® outside of the US, Canada or Mexico.
While the Luxe® battery is charging, the charger’s LED will glow red. It will glow green to indicate that the
charging cycle is complete. Charge time is approximately 30 minutes. The USB/SATA Luxe USB Interface
cable will not charge the battery.
ONLY USE THE LUXE® CHARGER, CIRCUIT BOARD AND GENUINE LUXE® BATTERY. THESE COMPONENTS CONTAIN
CRITICAL CHARGE AND DISCHARGE CONTROL CIRCUITS. USE OF AFTER-MARKET ELECTRONIC PARTS MAY
RESULT IN FIRE OR EXPLOSION.
When your Luxe® is turned on, it will display an estimate of the remaining battery charge. This will be
displayed at the bottom of the marker's OLED display. It is important to note that battery discharge rates
can be affected by various factors, including temperature. The indicated charge level is only an estimation
of the expected remaining charge life.
HarDWarE 3.6 rEPLaCING Or CHarGING THE SParE BaTTErY
SWAP LUXE® BATTERIES at least once every six months to maximize their operating life. A spare battery
that is unused for more than six months or stored completely empty may lose capacity or fail entirely.
Unload and degas your Luxe® following the instructions in this manual. Open the left side grip panel with a
5/64-inch allen wrench. Use a 1/16-inch allen wrench to remove the speaker mount. [FIG 1.]
Carefully lift out the speaker. Do not allow sharp tools like allen wrenches to snap onto the magnet, damag-
ing the speaker cone. Take care not to strain the speaker wires. Lift out and unplug the the Lithium-Polymer
battery pack. When unplugging any component from the circuit board, pull on the connector directly, not its
wires.
DO NOT PLUG A BATTERY INTO THE SPEAKER CONNECTION [FIG.2,] AS CIRCUIT BOARD DAMAGE MAY RESULT.
Install a charged battery [FIG. 3,] and plug it into the circuit board. Make sure the speaker is plugged in,
reinstall the speaker and speaker mount, taking care not to crimp or crush any of the wires, then re-secure
the grip panel. The speaker and battery connectors only fit in one direction. If a connector does not slide
smoothly onto its pins, try rotating it to determine if it has been reversed. Do not force the connectors.
FIG. 1
FIG. 2
FIG. 3
PaGE 17
3.4 LUXE® BarrEL SYSTEm
To Next Page
Loading...
