ORIENTATION 1
AIR 2
HARDWARE 3
SOFTWARE 4
MAINTENANCE 5
aDV. maINTENaNCE 6
1
2
3
aDVaNCED maINTENaNCE 6.2 SErVICING THE VErTICaL rEGULaTOr
SERVICE AND ADJUSTMENTS TO THE REGULATOR WILL CAUSE CHANGES IN ITS OUTPUT PRESSURE. RE-ADJUST THE
REGULATOR FOR THE CORRECT VELOCITY USING A CHRONOGRAPH AS DESCRIBED IN THE MARKER’S MANUAL.
STEP ONE rEmOVE rEGULaTOr FrOm aSa
WITH THE LUXE® UNLOADED AND DEGASSED, use a 5/16-inch allen wrench to unscrew the Luxe® vertical
regulator from the bi-directional ASA. Hold the regulator cover to prevent it from turning with the regulator.
Inspect and clean the o-ring at the top of the regulator, then lubricate it with GR33SE™.
STEP TWO rEmOVE rEGULaTOr COVEr
INSERT A 3/8-INCH ALLEN WRENCH into the top of the Luxe® regulator, and a 3/8-inch allen wrench into the
cover lock at the bottom. Turn the allen wrenches counter-clockwise relative to one another to unscrew the cover
lock, and slide the Luxe® regulator out of its cover. Clean and inspect both o-rings on the bi-directional ASA
fitting at the top of the regulator, and replace if damaged. Lubricate both o-rings with GR33SE™.
STEP THrEE DISaSSEmBLE rEGULaTOr HOUSING
USE A 5/64-INCH ALLEN WRENCH to remove the two lock-screws from the sides of the Luxe® regulator.
Using a 3/8-inch allen wrench in the top regulator housing, insert a 5/16-inch allen wrench into the lower
regulator housing and turn the two counter-clockwise relative to one another. Remove the lower regulator
housing from the upper.
To Next Page
Loading...
