LUXEPaINTBaLL.COm
866.573.LUXE(5893)
5
STEP FOUr INSPECT BaLL DETENT PLUNGEr
CLEAN AND INSPECT THE BALL DETENT PLUNGER in the ball detent assembly. It should move freely when
pressed in and released. If the plunger or the Quick-Strip latch tension o-ring show significant signs of wear or
binding, replace them following the instructions in
ADVANCED MAINTENANCE 6.3.
STEP FIVE rEINSTaLL DETENT
REINSERT THE BALL DETENT ASSEMBLY by hooking its pointed edge into the front side of its pocket in the
Luxe® body. Then angle the rear into place, allowing the rare-earth magnets to grip and secure it in place. Make
sure that the latch has clicked into the locked position. Test the latch by pressing on the forward point of the
detent assembly to make sure it does not pop out.
4
PaGE 27
5.2 BaLL DETENTS & VISION EYES
2
3
STEP TWO rEmOVE DETENT aSSEmBLY
GRASP THE BALL DETENT ASSEMBLY from the rear, and lift outward, away from the Luxe® body.
STEP THrEE CLEaN VISION EYE POCkET
LIFT OUT THE VISION EYE from its pocket in the Luxe® body. Using a soft cloth or cotton swab, clean any
paint, debris or grease from the passage between the eye pocket and the breech, or from the eye itself. If
debris buildup is severe, use a cotton swab dampened with rubbing alcohol for cleaning the Vision eye and its
pocket and allow them to dry completely before proceeding. Take care not to scratch the Vision eye or strain
its flex-strip circuit. Gently re-seat the Vision eye in its pocket, with its emitter or sensor facing inward.
To Next Page
Loading...
