DMXking.com • JPK Systems Limited • New Zealand
0128-700-4.0
8
SETTINGS TAB
Make changes as required then click “Update” to save settings in your LeDMX4 PRO unit.
The following table explains each of the settings parameters.
Frequency LED strip receives updates from Incoming Universe data. Universe Sync takes
precedence.
Pixel output master level control for all outputs. Has no effect for Raw Colour Order modes
and is overridden by Playback Universe Master Level (see Recorder Manual).
Pixel output master level control for all outputs when Alternate Mapping is in effect. Has no
effect for Raw Colour Order modes.
Alternate mapping priority
threshold
sACN Priority below which Alternate Mapping parameters are used if no higher Priority sACN
stream is present. Threshold is assessed on the Start Universe only.
Alternate mapping priority threshold. When incoming stream priority is > threshold then Primary mapping applies. Priority <=
threshold Alternate mapping applies. For Primary source 100 Priority and Alternate source 50 set threshold between 50 and 99
for example. Note only first universe mapped to pixel port is used to determine priority.
To Next Page
Loading...