DoAll C-916 - Page 3

OPERATOR'S INSTRUCTION MANUAL
0
0
MODEL
FIRST SERIAL NO. LAST SERIAL NO.
C-916 438-83104
Dall
0
MACHINE MODEL MACHINE SER. NO.
IC-gib
I
I ~ ?, ~ - ~ LJ l 'i:_ l I
~
TOTAL MACHINE ELECTRIC POWER INPUT DATA
VOLTAGE PHASE
HERTZ
NORM . AMPS.
INT. RATE . AMPS RMS SYM. A.C.
I 4 R'O I
I '?:::i
I I
(; o I
I I
I
LARGEST CONTROLLED MOTOR F. L.A .
OVERCURRENT PROTECTION PROVIDED
I
I
AT MACHINE SUPPLY TERMINALS
BAND LENGTH
I
1s~;l'"I,
I
BELT NUMBERS
DRIVE
DRIVEN
SPEED IND . -BRUSH
I
Q- l S~ K
I
X
I I
:::::.t
I I I
::J
ELECTRIC SCHEMATIC NO.
HYDRAULIC SCHEMATIC NO.
I I
I I
ADJUSTMENT SUMMARY NUMBERS
I
I I
I I
SEE INSTRUCTION MANUAL FOR MACHINE
OPERATION AND LUllRICATION DATA.
304]01 0
For your information and future reference, pertinent data
concerning your machine should be written in the spaces
provided above. This information is stamped on a plate attached
to your machine. Be sure to provide machine model and serial
numbers with any correspondence or parts orders.
The specifications contained herein were in effect at the time
this manual was approved for printing . The DoALL Company,
whose policy is one of continuous improvement, reserves the
right , however, to change specifications or design at any time
without notice and without incurring obligations.
Please read this manual carefully before operating the machine.
The following registered trademarks of the DoALL Company
appear in this manual: DoALL.
DoALL COMPANY
25 4 NORTH LAUREL AVENUE
DES PLAINES . ILLINOIS 60016 U.S.A.
PRINTED IN U.S.A.
PB-378.1 (5-84)