DoAll C-916 - Accessories; Swivel Vise Jaw; Workstop Adjustment; Single Roller Stock Stand

ACCESSORIES
SWIVEL VISE JAW
To set angle vise jaws:
(1) Loosen fixed jaw lock screw .
(2) Rotate fixed jaw to desired angle . Tighten lock
screw .
(3) Loosen moveable jaw lock screws . Push
moveable jaw up to fixed jaw and tighten lock
screws . See Fig. 22.
FIXED
LOCK
MOVEABLE JAW
FIG. 22. SWIVEL VISE JAW ASSEMBLY SET-UP FOR ANGLE
CUTTING.
NOTE: Swivel vise jaw assembly requires a special
stock unloading tray.
WORKSTOP ADJUSTMENT
(1) This optional feature is used along with a
special stock unloading tray to adjust both
stock cut-off length and width.
(2) The unit attaches to both unloading tray rails.
Adjust for stock length by loosening holding
screws and sliding stop along inch indicator
on right tray edge . Ti ghten holding screws on
both tray edges when desired cut-off length is
reached .
(3) A stop which can be positioned for varying
stock widths slides along the rod running
between table side clamps. Position this stop
where desired and tighten lock screw .
(4) Push stock until it contacts stop; then adjust
and clamp machine's moveable vise jaw. See
Fig . 23.
16
I
~ LOCK
::::::------- SCREW
LOWER STOP -- ~
TO POSITION ~ I
WORK
STOP IN
RAISED
POSITION
FIG. 23. WORKSTOP MOUNTS TO STOCK UNLOAD ING TRAY .
NOTE: When not needed, the workstop can be
loosened and swung into a raised position.
SINGLE ROLLER STOCK STAND
This stand provides outboard suppo rt for l ong
stock. Assemble it by r eferring to Fig. 24 and
following these directions :
(1) Insert hex shaf t (No . 1) into roller(No. 2).
(2) Attach shaft and roller to legs (No 's. 3,4,5,6)
with hog rings (No. 7).
(3) Attach 2 support bars (No. 8) to legs and
support brac k et (No . 9) to support bars with
furnished hex cap screws , nuts, and washers.
(4) Adjust legs so bottom angles rest evenly on
floor. Securely tighten cap screws.
(5) Attach diagonal support bar (No. 10) with hex
screws, nuts, and washers .
RING
(No. 7)
DIAGONAL
ROLLER
(No. 2)
BAR ----;!'-f-..,.,,.,~\
(No.10)
LEG
(No . 6)
FIG. 24 . SINGLE ROLLER STOCK ST AND.
LEG ( No. 3)
•
•
•
■
•
•
•
lrJ
lo
•
Ii
I