Dockmate SINGLE - Installation; Installation of the Receiver

10
3. INSTALLATION
The installation must be done by a qualified technician.
Our system consists of two major components: a remote and a Receiver. These have already been
paired so they recognise each other.
Detailed installation instructions can be found in the installation manuals supplied with the Dockmate.
3.1. INSTALLATION OF THE RECEIVER
Dimensions Rev.G+ : 23.8 x 20.5 x 8.6 cm or 9.4 x 7.9 x 3.2”
Install the Receiver in a dry, not too warm area.
Install the Receiver free of vibrations.
Place the Receiver behind or close to the dashboard, and as close as possible to the controls of the
required functions (engine/motor controls, horn, anchor winch or windlass, bow- and stern thrusters).