51
7. STATIC ERROR CODES
The software of the remote has built in safety features to check upon start-up whether
one of the buttons is pressed. While the stat LED is on, and the link LED is off (about 2s),
the user cannot press any button. Otherwise, the software will recognise this as a fault
situation (signalling a STATIC ERROR CODE) and will switch off the unit. When this
happens, the remote needs to be restarted. As soon as the stat LED is off and the link
LED is on, the user may start using the Dockmate remote.
If after switching on, the link LED is constantly violet , that means that the remote encountered
a problem and it displays a STATIC ERROR CODE. The status LED will simultaneously display the error
code: the cycle starts with one yellow blink, then followed by one or more RED blinks (+ beeps &
vibrations); the cycle ends with a 0.5s break. After 10 cycles, the remote switches itself off.
To Next Page
Loading...
