52
Possible STATIC ERROR CODES are:
Code #1. No Communication with the joystick.
Code #2. Joystick is not in neutral during start-up.
Code #3. One or more buttons pressed during start-up. No button, except On / Off may be
pressed when switching on the remote.
Code #4. Joystick stuck during operation and could not be reset.
Code #5. Joystick responded with faulty checksum.
Code #6. Remote is disabled due to previously detected fault in a joystick (code 4 or 5).
Code #7. Serial Number in remote is not set. The remote doesn’t have a serial number.
Code #8. Trying to use demo remote as a normal unit. The remote has the DEMO FLAG set but
the serial number is different than 1, 2, 3 or 4.
Code #9. Powered charger detected while remote is in use.
To Next Page
Loading...
