36
When DPS is activated, the “stat” LED will light blue , and blinks the entire time this
function is engaged. When the “sel” button is pressed for 1s or more again, it
deactivates DPS, the remote beeps twice, and the “stat” LED will stop blinking blue
Dockmate is not responsible for active movements made by the boat, while DPS is
activated. Your boat’s DPS is controlled by the host system (Volvo Penta EVC, Mercury
Joystick Piloting, …). Turning off your Dockmate remote does not (de)activate the DPS
system. Check your boat’s DPS operation manual, before using it.
• Anchor winch buttons
By pressing the upper button, you lower the anchor.
By pressing the lower button, you raise the anchor.
This behaviour can be switched in the Dockmate Settings, during the installation or sea trial.
These buttons only operate an anchor winch if installed on the boat and your Dockmate
Receiver is configured for it. Otherwise, this has no effect. When pressed together, you can
choose between windlass 1 and 2 (2 or 4 beeps), if the Dockmate Receiver is fitted with a twin
anchor winch module.
To Next Page
Loading...
