116
116
6.6 Protection of power supply
Protection against overcurrent resulting from Overvoltage (EN 0204-1, § 7.2)
The power supply of the multifunction safety module BI 5910 with radio control is protected
with an internal PTC.
6.7 Minimum and maximum output current
Please make sure, that the minimum and maximum values stated under 5.2 are not exceeded.
If necessary install additional loads or interfacing relays. (contact reinforcement in cabinet).
6.7 Emergency operation
It must be possible to change to a different control system when a remote control is defective
in order to provide safety to the operator in the case of hanging load.
6.6 Protection of power supply
Protection against overcurrent resulting from Overvoltage (EN 0204-1, § 7.2)
The power supply of the multifunction safety module BI 5910 with radio control is protected
with an internal PTC.
6.7 Minimum and maximum output current
Please make sure, that the minimum and maximum values stated under 5.2 are not exceeded.
If necessary install additional loads or interfacing relays. (contact reinforcement in cabinet).
6.7 Emergency operation
It must be possible to change to a different control system when a remote control is defective
in order to provide safety to the operator in the case of hanging load.
To Next Page
Loading...
