DOLD BI 5910 - Battery Operation - Storage Rules for Remote Control RE 5910; Load Battery; Indication of Battery Load State

79
79
On the remote control there are 2 possibilities
to indicate the charging state:
- When activating the remote control (release
of e-stop button) the red LED shows the
state of the battery:
red LED OFF battery charged > 50%
red LED flashes slowly: battery charged
between 10% and 50%
red LED flashes fast: battery charged < 10%
it must be loaded immediately.
- When operating the remote control (radio
transmission) a low battery state (battery
charged < 10%) is indicated by a fast flashing
red LED. The user is informed, that the remote
control will be deactivated in short time ( within
approx. 15 minutes).
3.7.2 Indication of
charging level
3.7 Battery operation –
storage recommendations
The remote control RE 5910 has to be
stocked with charged battery.
3.7.1 Charge battery
To charge battery:
- press e-stop button of remote control
- place remote control on charger unit
During charging the red LED of the remote
control is continuously on, while the green LED
shows the charging level:
Green LED flashes: Quick charge active
Green LED ON: Slow charging or charge
conservation (charging level of RE 5910 >60%)
On the remote control there are 2 possibilities
to indicate the charging state:
- When activating the remote control (release
of e-stop button) the red LED shows the
state of the battery:
red LED OFF battery charged > 50%
red LED flashes slowly: battery charged
between 10% and 50%
red LED flashes fast: battery charged < 10%
it must be loaded immediately.
- When operating the remote control (radio
transmission) a low battery state (battery
charged < 10%) is indicated by a fast flashing
red LED. The user is informed, that the remote
control will be deactivated in short time ( within
approx. 15 minutes).
3.7.2 Indication of
charging level
3.7 Battery operation –
storage recommendations
The remote control RE 5910 has to be
stocked with charged battery.
3.7.1 Charge battery
To charge battery:
- press e-stop button of remote control
- place remote control on charger unit
During charging the red LED of the remote
control is continuously on, while the green LED
shows the charging level:
Green LED flashes: Quick charge active
Green LED ON: Slow charging or charge
conservation (charging level of RE 5910 >60%)