DOLD BI 5910 - Page 88

To Next Page

To Previous Page

3.9.3 Time delay of activity monitoring

(Automatic disconnection of remote control)

The time interval is fixed by 2 parameters

1. The time base i.e. seconds or minutes

2. The time interval

3.9.3.1 Programming of time base – activity monitoring

1. Disconnect the multifunction safety module BI 5910 with radio control.

2. Insert the electronic key into the remote control.

3. Keep the button B1 pressed,

- Release the e-stop button (pic.1),

- Release button B1

The red LED is ON when minutes are selected,.

The green LED is on when seconds are selected.

4. The time base can be changed by pressing B2 (Pic.2). During this procedure the momentarily

selected time base is indicated on the LEDs.

5. The selected time base (minutes or seconds) is confirmed by pressing start (Pic.3).

6. Leave the programming mode for activity monitoring by pressing e-stop. (Pic.5).

Attention: When selected minutes and delay time 99 the time is infinite. If unintentionally the

remote control is not de-activated it will discharge completely.