Dolmar MS-24 U - Protector Mounting; Metal Blade Protector Mounting; Nylon Cutting Head Protector Mounting

11
To meet the applicable safety provisions, only the tool/protector combinations as
indicated in the table must be used.
Be sure to use genuine DOLMAR cutter blades or nylon
cutting head.
The cutter blade must be well polished, free of cracks or breakage. If the –
cutter blade hits against a stone during operation, stop the engine and check
the blade immediately.
Polish or replace the cutter blade every three hours of operation. –
If the nylon cutting head hits against a stone during operation, stop the –
engine and check the nylon cutting head immediately.
Star Blade
Nylon cutting headProtector for metal blades Protector for cord cutter
MOUNTING OF PROTECTOR
CAUTION: The appropriate protector must always be installed, for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place is not
permitted.
(1)
(3)
(2)
(1)
(4)
(6)
(5)
When using the string head, t the protector (6) into the protector (1), and –
tighten them with two nuts (5) and two screws (4).
Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2). –