9
EN
Refrigerators Diagnostic Procedures
Component Diagnostic Question Action Based On Status Page
Door Assembly
Does the compressor run constantly or
turn on/off frequently?
• Verify that the door seals and closes
properly.
• Adjust any door and/or seal issues as
needed.
14
Does the door seal and latch properly to
the unit?
• Verify that the door seals and closes
properly.
• Adjust any door and/or seal issues as
needed.
14
• For CR series models, verify that the
thermostat assembly is installed correctly.
• Adjust the thermostat assembly as
needed.
15
Does the unit reach the appropriate
cooling temperature and/or is there
excessive frost inside the unit?
• Turn the dial to the coldest setting, and let
the unit run for fieen minutes.
• Verify that the unit is cooling according to
the specified settings.
N/A
Does the door assembly still not function
properly aer performing the above
diagnostic tests?
Replace the door assembly. 14
NTC Sensor
Does the unit not hold the set
temperature or does it warm too quickly?
Ensure that the vent mechanism is not set to
the "vent" position.
N/A
Is the unit attempting to start, but then
stops?
• Verify that the sensor is properly
connected and powered.
• Fix any wiring and/or power issues as
needed.
6
Is the thermostat assembly red indicator
light flashing?
• Check the thermostat assembly.
• Determine whether the red indicator light
is flashing in sequence.
11
To Next Page
Loading...
Need help?
General
