Operating the system Connect Panel
12
5 Operating the system
5.1 Basic operation
I
Control unit
You can access menus and enter settings as follows:
• by touching the sensor buttons
• by touching a symbol on the navigation bar
• by touching a symbol on the display which has a rectangular frame
An activated function is displayed with a highlighted background.
Touc h log ic
If only one setting is available (e.g. air conditioner ON/OFF):
➤ Press the corresponding touch symbol.
✓ The corresponding setting is displayed.
If several settings are available (e.g. air conditioner modes or fan speeds):
➤ Press the corresponding touch symbol multiple times until you reach the desired
setting.
✓ The corresponding setting is displayed.
NOTE
Symbols are only shown on the display if the corresponding vehicle
technology is connected. The symbols and settings displayed can vary
depending on the manufacturer and model.
Item in
fig. 1, page 3
Explanation
1 Status bar
2 Control panel
3 Navigation bar
4 Sensor buttons
ConnectPanel -O-8s.book Seite 12 Dienstag, 31. März 2020 6:13 06
To Next Page
Loading...
Need help?
General
