INSTALLATION INSTRUCTIONS
2-10 EPT009665 Issue 2 May 2015
Attention should be paid to complete mains power disconnection in case of
failure or service. Disconnect the TouchPanel from AC mains power and
from the BCP7 controller. All cables may be disconnected from the
TouchPanel after disconnecting the TouchPanel from power (BCP7
controller Ethernet connection and AC mains power).
The power supply of the TouchPanel’s internal power supply depends on:
• If a BCP7 controller is connected via Ethernet to the TouchPanel and/or
• If the AC mains supply of the TouchPanel is used.
Both power connections (BCP7 controller Ethernet connection and AC
mains power) may be used in parallel.
To Next Page
Loading...
