INSTALLATION INSTRUCTIONS
2-46 EPT009665 Issue 2 May 2015
With Shutter
The fibre laser F220i may be optionally equipped with a laser beam
attenuator. This mechanical shutter is part of the fibre laser safety concept.
The shutter is located between laser source and scan head and electrically
connected with the fibre laser controller box.
The shutter is intended for single product marking where the guard door is
frequently opened and closed between the prints. The graphic below
shows the components related with the safety function:
Control Board
Coil
Shutter Blade
BCP 7
Controller
Laser Unit
F220i
To Next Page
Loading...
