To Next Page

To Previous Page

PSS5000/CONF/804473/40 13 of 54

PSS 5000 – Hardware Configuration Guide

Selecting the CPU Board and Interface Modules

2.2 Tank Gauge System (TGS) Manufacturers and Protocols

List of TGS

manufacturers and

protocols

A list of the Tank Gauge System (TGS) manufacturers and supported proto-

cols are shown in the table below:

Note: The HIM used with specific TGSs depends on both the electrical inter-

face(s) and protocol(s) supported by the individual TGS. To obtain this

information, use the manufacturer's technical documentation for the

specific TGS.

Manufacturers Protocols

4tech ‘4Tech Fuelcom 501’ on page 22

B Control A (CMS) ‘B Control A (CMS)’ on page 22

Egemin Naamloze ‘Egemin LGS2’ on page 22

Enraf ‘Enraf STIC 867 (GPU)’ on page 22

Fafnir ‘Fafnir Visy-Quick’ on page 22

‘Fafnir UDP’ on page 22

Hectronic ‘Hectronic H-Protocol’ on page 22

‘Hectronic HLS Protocol’ on page 22

‘IFSF’ on page 22

Incon ‘Veeder-Root’ on page 22

Labko ‘Veeder-Root’ on page 22

Lemis Baltic ‘Lemis DC-400’ on page 22

Omntec ‘Veeder-Root’ on page 22

OPW ‘Veeder-Root’ on page 22

Petro Vend ‘Petrovend4’ on page 22

‘IFSF’ on page 22

Scientific & Production

Enterprise SENSOR LLC

‘Sense PMP’ on page 22

Struna ‘Struna-M’ on page 22

START Italiana ‘Veeder-Root’ on page 22

Veeder-Root ‘Veeder-Root’ on page 22

‘IFSF’ on page 22

Doms PSS 5000 Hardware Configuration Guide

Other manuals for Doms PSS 5000