33
1800-060 Issued 7-19
Version A
01
? ? ? ?
4
4
01
? ? ? ?
5
4
This programming sequence will change the factory set 16-Digit Phone Number programming to 7-Digit Phone Number
programming. DoorKing DOES NOT RECOMMEND using 7-Digit Phone Number programming for a NEW phone entry system.
Factory setting is 0 (NO).
7-Digit Phone Number programming sections 3.2.8 - 3.2.13 will ONLY need to be used when more than 600 Phone Numbers
are needed (not typical) OR installing an OLD memory chip in a NEW phone entry system (from an old phone system that has
previously programmed information on it). DoorKing does not recommend using an old memory chip. Reprogramming the new
memory chip with existing information will take some time but will save time when programming and operating the unit in the
future.
DoorKing DOES NOT RECOMMEND using 7-Digit Phone Number programming for a NEW phone system. It is more complex to
program and and limits the features available compared to 16-Digit Phone Number programming.
Section 3.2.1 - “Directory Code Length” MUST be programmed before section 3.2.10 can be programmed.
Section 3.2.2 - “Pause Time” # key will NOT function when programming 7-Digit Phone Numbers.
Section 3.2.4 - “Delete Individual Phone Number” will NOT work for 7-Digit Phone Number programming. Use section 3.2.13.
Sections 3.2.5 - 3.2.7 - “Delete and Display” programming WILL function when using 7-Digit Phone Number programming.
Section 3.2.8 - “7-Digit Phone Number Capability” MUST be programmed to YES before section 3.2.10 can be programmed.
3.2.8 7-Digit Phone Number Capability
7-Digit Phone Number Programming - Limited Use
CAUTION: If 7-digit programming is turned ON (1-YES), All previously
programmed phone numbers and directory codes will be ERASED.
1. Press and enter your four-digit MASTER CODE (beep).
2 sec. LCD display on 1803 & 1810 models will read: 7 DIG?.
...then the LCD display will read: 1=Y 0=N.
2. Press (beep) for YES, OR (beep) for NO.
The 1 “YES” LCD display will read: ERASING. This CANNOT be UNDONE! Programming sequence will automatically
end itself when finished by a long (beeeeeep).
This programming sequence DOES NOT need to be changed when using 16-Digit Phone Number programming. This ONLY
needs to be turned back ON (1-YES) if you want to change 7-Digit Phone Number programming back to 16-Digit Phone Number
programming. DoorKing ALWAYS RECOMMENDS using 16-Digit Phone Number programming for a phone entry system.
Factory setting is 1 (YES).
3.2.9 16-Digit Phone Number Capability
CAUTION: If this programming is turned back ON (1-YES), All previously
programmed phone numbers and directory codes will be ERASED.
1. Press and enter your four-digit MASTER CODE (beep).
2 sec. LCD display on 1803 & 1810 models will read: 16 DIG?.
...then the LCD display will read: 1=Y 0=N.
2. Press (beep) for YES, OR (beep) for NO.
The 1 “YES” LCD display will read: ERASING. This CANNOT be UNDONE! Programming sequence will automatically
end itself when finished by a long (beeeeeep).
To Next Page
Loading...
