6
3.4.8 Delete Area Codes
This program sequence deletes area code numbers that have been programmed into the system.
1. Press
and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the area code reference number (0 through 9) _ then press
(beep).
3. Enter
then press
(beep).
4. Repeat steps 2 and 3 to delete additional area codes.
5. Press
TOGETHER to end this programming step (beeeeeep).
3.4.9 Display Phone Numbers
Use this programming sequence to display phone numbers programmed under known directory
codes, i.e. if you wanted to see what phone number was programmed under directory code 271. This
programming sequence will not allow you to delete phone numbers.
1. Press
and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press
(beep).
3. The phone number programmed under the directory code entered in step 3 will be
displayed on the LCD. If
C C C C C C C
is displayed, this indicates that no phone
number has been programmed under the entered directory code. If the first digit is
flashing, this is the area code reference code and indicates that the number
displayed is a long distance or 10-digit number.
4. To display additional phone numbers press
and repeat step 2.
5. Press
TOGETHER to end this programming step (beeeeeep).
To Next Page
Loading...
