DoorKing 1814 - Four-Digit Entry Codes

3
7
Four-digit entry codes are entered on the system keypad preceded by # to allow the resident access.
Do not confuse four-digit entry codes with a five-digit device code entered from a weigand keypad.
3.5.1 Programming Four-digit Entry Codes
1. Press

and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press

(beep).
3. Enter the four-digit entry code _ _ _ _ then press

(beep).
4. Repeat steps 2 and 3 to enter additional entry codes.
5. Press

TOGETHER to end this programming step (beeeeeep).
3.5.2 Delete Four-digit Entry Codes
1. Press

and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press

(beep).
3. Press

(beep).
4. Repeat steps 2 and 3 to delete more entry codes.
5. Press

TOGETHER to end this programming step (beeeeeep).
3.5.3 View Four-digit Entry Codes
1. Press

and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.4.1) then press

(beep).
3. The entry code programmed under the directory code entered in step 2 will be
displayed.
4. Repeat step 2 to view additional entry codes.
5. Press

TOGETHER to end this programming step (beeeeeep).
3.5.4 Entry Code Ranges
Four-digit entry codes can be made to activate relay 1, relay 2 or any combination of relays by
programming HI and LOW ranges for each relay. Ranges may overlap, which will cause more than
one relay to activate if this is desired. For example, if the low boundary for relay 1 and relay 2 is
2000, and the hi boundary is 3000 for relay 1 and 4000 for relay 2, then entry codes between 2000
and 3000 will activate both relays, and entry codes between 3001 and 4000 will only activate relay 2.
1. Press

and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Press

to set relay 1, or

to set relay 2 boundaries.
3. Enter the four-digit low boundary _ _ _ _ then press

(beep).
4. Enter the four-digit high boundary _ _ _ _ then press

(beep).
5. Repeat steps 2, 3, and 4 to set the other relay boundaries (or proceed to step 6).
6. Press

TOGETHER to end this programming step (beeeeeep).
3.5 FOUR-DIGIT ENTRY CODES