25
1838-065 Issued 3-19
Version D
Program from System Keypad ONLY
3.2 Set-up 1838 Access Controller for PC Programming
1838 keypad is located
INSIDE enclosure.
Prior to using a PC to program this PC Programmable 1838 access controller with the DoorKing Remote Account Manager for
Windows software, section 3.2 factory settings MUST be reviewed or re-programmed if necessary (most factory settings are
typically desired). There is no need to re-program these settings unless you want to change them. For easy reference, refer to
the chart on page 29 that list the various programming functions and their factory default settings. Section 3.2 can ONLY be
programmed from the 1838 Keypad. There is NO programming sequence in the Remote Account Manager Software to
program these features with.
This programming step sets the 1838 MASTER CODE. The master code is the four-digit number REQUIRED to gain access to
the 1838 memory. You need to know the master code prior to programming the 1838 with the PC, or to perform ANY of the
programming functions on the following pages. It MUST be programmed in from the 1838 keypad.
NO Factory setting - Each 1838 access controller’s master code MUST be unique.
See section 4.1 for more information about the master code switch.
Important Note: If you make a mistake while programming, press keys at the same time
to escape from programming no matter how much has been completed, then begin again at step 1.
1. Open the enclosure of the 1838 and turn the master code switch ON.
2. Enter a four-digit master code then press (beep).
3. Turn the master code switch OFF and close the enclosure.
3.2.1 Master Code
NC
NO
NO
RING
NC C
ON
SPK
VOL
FEED
BACK
RS 232
ELEVATOR
12345 67 891011121314
1
2
3
MIC
VOL
OFF
KEYPAD
321
321
321
MASTER
CODE
16AC16ACBAT1NO1NC1C2RY2CAZIMC5VDCIMDSPKRCOMMICPSWCGNDPHONE
? ? ? ?
Important Note: There is no way of retrieving the master code after it has been programmed in. If you forget it, you will have to
program in a new one but all other previously programmed information will remain intact.
0
TONE ON
TONE OFF
7 8 9
4 5 6
1 2 3
0
ON
MASTER
CODE
OFF
ACT
To Next Page
Loading...
