Vehicle Systems Disassembly & Assembly 32
8. Remove drive.
9. Remove spacer plate.
10. Remove seal from housing.
11. Remove housing from vise. Place housing on a
clean soft cloth to protect surface finish. Use a
thin bladed screwdriver to pry retaining ring
from housing.
12. Rotate spool and sleeve until pin is horizontal.
Push spool and sleeve assembly forward with
your thumbs just far enough to free gland
bushing from housing. Remove bushing.
13. Remove quad ring seal from seal gland bushing.
14. Use a thin bladed screwdriver to pry dust seal
from seal gland bushing. Do not damage
bushing.
IDCD281S
Seal
Drive
Spacer Plate
IDCD282S
Control End
IDCD283S
Seal Gland
Bushing
IDCD284S
Seal
Gland
Bushing
Quad
Ring
Seal
Dust
Seal
Bearin
To Next Page
Loading...
Need help?
General
