Vehicle Systems Disassembly & Assembly 37
21. Rotate spool and sleeve assembly until pin is
parallel with port face. Install drive, make sure
you engage drive with pin. To assure proper
alignment, mark drive as shown. Note
relationship between slotted end of drive to
splined end of drive when marking.
22. Install 73.5 mm [2.89 in.] ID seal in spacer plate
or gerotor (meter).
23. With seal side of meter toward spacer plate,
align star valleys on drive. Note the parallel
relationship of reference lines A, B, C, and D.
Align bolt holes without disengaging meter from
drive.
IDCD298S
Drive
Port Face
Pin
Pin Parallel
with Port
Face
IDCD299S
Seal
IDCD300S
Drive
(Marked)
Star Valley
Pin
Port Face
Seal Groove this Side of Gerotor (Meter)
A
B
C
D
To Next Page
Loading...
Need help?
General
