Vehicle Systems Disassembly & Assembly 55
11. Insert the through shaft (33) into driving shaft
(11), and then locate the working body (2) and
flange (32) after inserting the squaring ring (26)
to body (2).
Smear clean grease on the square ring (26) to
avoid drifting away of square ring from the
working body (2).
Rear section
1. Locate the o-ring (23) on the groove pre-arranged
on the thrust plate (8).
2. Then, locate back-up ring (29) on the groove pre-
arranged on the seals (8, 23).
Smear clean grease on the seal(8,23)
(The front and rear thrust plates and seals and
back-up ring are same.)
3. Locate the driving gear(10) and driven gear(12)
with thrust plate parts(8+23+29) into working
section(2).
4. Insert the dowel pin(35) into the working section
(2) and then, locate the rear working section (1) to
working section (2) while keeping the gear straight.
Smear clean grease on the square ring (26) to
avoid drifting away of square ring from the rear
working section (1).
5. Locate the rear cover(4) after inserting the
square ring(26) and the dowel pin(35) into the rear
working section(1).
Smear clean grease on the square ring(26) to
avoid drifting away of square ring(26) from the
rear cover(4).