Vehicle Systems Disassembly & Assembly 60
11. Remove bolts (14) and nuts from two engine
mounts, located on each side of the engine.
NOTICE
Make sure the engine is supported underneath by
suitable wooden blocks. Failure to support engine
will result in possible damage.
13. Remove the engine with a hoist.
14. Install the engine in the reverse order of removal.
End By :
a. Install hydraulic control valve *
b. Install floor plate.
c. Install hood (with seat) assembly *
d. Install counterweight *
e. Install Overhead guard.*
* Refer to the topics “Hydraulic Control Valve”,
“Hood (with seat) Assembly”, “Counterweight” and
“Overhead Guard”.
To Previous Page
Loading...
Need help?
General
