022-00029AE Operation and Maintenance Manual Operating Controls 2-9
6. BRAKE PEDAL (RIGHT AND LEFT
PEDALS)
Pressing brake pedal will apply the brakes
to the loader. The brake pedal modes can
be switched over from inching to no-
inching or vice-versa, by using the
transmission cutoff switch (See page
2-31).
7. STEERING WHEEL
Rotating steering wheel controls position
of front wheels and this determines
direction of machine travel.
CAUTION!
When descending on an incline, slow
down the truck by using both the
brake pedal and the engine brake.
Using the brake pedal too often
might lead to insufficient oil
pressure, thus making it difficult to
brake the loader.
IMPORTANT
Do not use brake pedal as a foot rest.
This will cause brake disc to wear
faster than normal, and this could
cause brake failure.
Figure 11
Figure 12
To Next Page
Loading...
