Dorma ED800 J User Manual

ED800-3
SUGGESTED TOOL LIST
The following is a list of tools required for the installation of the ED 800. Additional tools may be required for installation of
the various types of actuators and accessories.
1. Long No. 2 Phillips screwdriver
2. No. 3 Phillips screwdriver
3. 1/8" blade screwdriver
4. 3/16" blade screwdriver
5. Tape measure
6. 10" Adjustable wrench
7. Center punch
8. Hammer
9. 5mm Hex key
10. 6mm Hex key
11. 3/8" Drill
12. No. 7 (0.201") Drill bit
13. 5/32" Drill bit
14. 3/8" Drill bit
15. 7/8" Hole saw
16. 1/4 - 20 Tap
17. Safety glasses
18. ED 800 Installation Video
08102710 05/07

Dorma ED800 J Specifications

Power

voltage	120 Volts AC
operating frequency	50/60 Hz
current	2 Amp

Fuse Specifications

fuse current	3 Amp
fuse type	type AGC
fuse size	1/4" x 1 1/4"

Auxiliary Power Output

auxiliary voltage range	10 to 25 Volts DC
auxiliary current	500mA
relay contact rating	48 VAC/DC @ 1 Amp Max.

Radio Frequency Receiver

frequency	300 MHz std. or 310 MHz jumper selectable
supply voltage	12 - 30 Volts AC/DC
power consumption rest	16mA

Wall Switch Specifications

switch type	SPDT
switch rating	15 Amp @ 125 or 250 Volts AC
battery type	9 Volt NEDA 1604