31
UNIVERSAL COUNTERFEIT DETECTOR DORS 1300
TROUBLESHOOTING
The device fails to switch on (the power switch key doesn’t light).
Check the device connection to the power supply.
Fuse F1 (2.0A, 250V) on the CPU power board has failed. Apply to the ser-
vice center.
There is a message “Change UV Lamp 1” (the message may contain ei-
ther a different number of the lamp or several lamps may be indicated).
A UV illumination fluorescent lamp corresponding to the indicated number
has failed. Apply to the electrician to replace the lamp in compliance with
the abovementioned instruction.
There is a message “Change white Lamp 1” (the message may contain
either a different number of the lamp or several lamps may be indicated).
The white fluorescent lamp for illumination of the viewing table correspond-
ing to the indicated number has failed. Apply to the electrician to replace
the lamp in compliance with the above-mentioned instruction.
There is no picture from an external video magnifier / there is no
changing over to the corresponding video input by pressing the select
key on the magnifier.
The magnifier connector might be not completely inserted in the V 1/V2 jack
of the device. Insert the connector into the jack till the stop.
.............................................................100 – 240 VAC, 50/60 Hz
Current consumption .........................................................................0.4 – 0.17 A
Weight ........................................................................................................2.3 kg
Overall dimensions (Width x Depth x Height):
The display is in a transportation position .......... 300 x 170 x 210 mm
The display is lifted by angle 90°........................300 x 170 x 324 mm
The display is lifted by angle 120°......................300 x 203 x 314 mm
Size of screen active zone............................................................154 x 86.6 mm
Size of viewing table window. ........................................................180 x 109 mm
Total power of UV-radiation source..............................................................18 W
Peak wavelength of UV-radiation .............................................................365 nm
Operating range of IR-radiation ...................................................800 – 1,000 nm
Two wavelengths at IR blink marks verifying ....................................850/940 nm
Video signal standard at connectors IN, OUT ............................ITU R BT.470-7,
peak-to-peak 1
V
Color coding standard ................................................................................... PAL
Linear magnification on display:
at the use of the built-in cameras ........................... 1x / 10x
at the use of the DORS 1020 ........................................22x
Operating temperature ..................................................................... +5 to +40°C
Design and specifications are subject to change without notice for product improvement. The
devices presented on the pictures may have some differences in appearance with serial production.
Supply voltage
SPECIFICATIONS
To Next Page
Loading...
