/ 33
Starting up the
DOSATRON
USING FOR THE FIRST TIME
• Partially open the water inlet.
• Gradually open the DOSATRON By-Pass valves while closing the main
valve
• Press the bleed button on the top cap.
• When a constant flow of water is seen coming from around the bleed button
(no “spitting” of air), release the button.
• Slowly open the fast priming valve located downstream of the DOSATRON.
• Let the DOSATRON run until the additive to be dosed rises in the injection
assembly (you will be able to see it through the transparent tube), then close
the fast priming valve.
• The DOSATRON makes a characteristic “click-clack” noise when operating.
To Next Page
Loading...
