/ 41
REMOVING THE SUCTION HOSE
WARNING: Before performing any work on the DOSATRON, you must
read to the Precautions section, page 17.
NOTA: Before dismantling, and to avoid any contact with the injected
additives, turn on the DOSATRON and allow it to draw in clear water in order
to rinse the injection assembly.
D9WL3000 / D9WL3000IE
• Unscrew the nut at the bottom of the injection assembly
• Remove the hose and its nozzle from the suction valve fitting by pulling it
downwards.
• Reassemble in the reverse order. If necessary, please refer to Connecting
the suction hose, page 24.
fig 30 fig 31
To Next Page
Loading...
