/ 39
Maintenance
WARNING: Before performing any work on the DOSATRON, you must
read to the Precautions section, page 17.
RECOMMENDATIONS
1.When using soluble products in solution, we recommend periodically
dismantling the entire injection assembly (refer to: Cleaning and refitting the
suction valve, page 53, Replacing the injection seals, page 45). Thoroughly
rinse all elements of the injection assembly with clear water and reassemble
them, having previously greased the seal (shown below) with a silicone-
based lubricant.
2.If your DOSATRON has not been used for a certain period of time, remove
the motor piston and soak it in lukewarm water (<40 ° C) for a few hours
before starting it up again. This will remove any deposits that may have dried
in the motor piston.
fig 27
To Next Page
Loading...
