DR All-Terrain FIELD and BRUSH MOWER User Manual

26 DR

ALL-TERRAIN

FIELD and BRUSH MOWER Safety & Operating Instructions
To Replace the Drive Belt
Tools Needed:
■ 7/16" socket
■ 1/2" wrench
■ 9/16" wrench
■ Gloves
1. Drain the gas and oil.
2. Remove the blade belt following the instructions as outlined in the previous page.
3. Remove the pin and collar (Figure 16), and then pull the power unit away from the
deck.
4. Tilt the power unit forward onto the attachment pin.
Figure 16
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire(s).
Remove Pin & Collar

DR All-Terrain FIELD and BRUSH MOWER Specifications

General

Brand	DR
Model	All-Terrain FIELD and BRUSH MOWER
Category	Lawn Mower
Language	English