CONTACT US AT www.DRpower.com 23
Troubleshooting Table (Continued)
SYMPTOM POSSIBLE CAUSE
The Belt frays or rolls
over the Pulley.
A Pulley groove may be nicked. Check the Belt for wear and hard spots. File off any nicks on the
Pulley.
The Belt may be stretched; replace it.
Blade vibrates when
engaged.
Replace the Blade if it is chipped, bent, or broken.
The Spindle Bearings may be bad or the Spindle Shaft is bent. Visit us at www.DRpower.com.
The Blade is not cutting
or is loose.
The Blade may not be seated properly on the hub. Loosen the Blade Bolt, reseat the Blade, and
tighten the Bolt. Be sure to turn OFF the Engine and remove the Spark Plug Wire before
performing this operation.
Sharpen the Blade; it may be dull or nicked.
Wheels pulling left or
right.
The Tires may not have the proper air pressure. Check the recommended Tire pressure on the
side of the Tire. Do not exceed the maximum pressure recommended.
The Wheels will not
drive.
The Transaxle is not in gear. Shift the Transaxle into gear.
Traction Drive Cable needs adjustment. See “Adjusting the Traction Drive Cable” in Chapter 4.
Shut down the engine, remove the spark plug wire and wait 5 minutes before performing any maintenance procedure or
inspection on the Mower.
To Next Page
Loading...
