EasyManuals Logo

DR ROTO-HOGTM User Manual

DR ROTO-HOGTM
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
CALL TOLL-FREE 1-800-DR-OWNER 23
Electric Starting
1. When starting a cold Engine, push the Choke Control Lever to the far right (CHOKE) and the Throttle
Control Lever to the far right FAST (RABBIT). See Figure 10 on page 19.
2. Turn the Key (Figure 14) all the way clockwise until the Engine starts, then release. The Key will snap
back to the RUN position and the Engine will continue to run.
3. After the Engine starts, slowly push the Choke Control Lever to the left (RUN) position (Figure 10 on
page 19). Wait until the Engine runs smoothly before each Choke adjustment. For optimum
performance of the DR ROTO-HOG POWER TILLER, you should operate the Engine with the Throttle
in the Fast (RABBIT) position (Figure 10 on page 19).
Stopping the Engine
Manual Start model: Move the Throttle (Figure 10 on page 19)
all the way back to the STOP position.
Electric-Start model:
Move the Throttle (Figure 10 on page 19)
all the way back to the STOP position, or;
move the Throttle to the SLOW (Turtle) position and turn the Key to OFF.
NEVER STOP THE ENGINE BY MOVING THE CHOKE LEVER TO THE CHOKE POSITION. THIS COULD
CAUSE AN ENGINE BACKFIRE RESULTING IN ENGINE DAMAGE.
Figure 14
Starter Key Switch

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DR ROTO-HOGTM and is the answer not in the manual?

DR ROTO-HOGTM Specifications

General IconGeneral
EngineBriggs & Stratton 8.75 FPT, 206 CC, Single Cylinder
Approximate Run Time on a Tank of Fuel90 minutes
Range7" to 2"
Actuator Stroke3.94"
Actuator Maximum Load250 lbs.
Battery12 Volt, 17AH
# of Cycles for Fully Charged Battery400
Towing typePin Hitch
Ground Clearance in Transport Mode2.75"
Height AdjustmentElectric Actuator
Length of Remote Control Cable46"
Tine Size12"
Number of Tines24
Wheels15" x 6.00"-6 NHS (14" x 5.5")
Gauge of Steel on Shroud13
Gauge of Steel on Frame12 Gauge, 1.5" Tubular Steel
Weight and Dimensions IconWeight and Dimensions
Machine Size39"w x 66"L (Transport), 35"H x 77"L (Lowest Position)
Machine Weight259 lbs. Manual Start, 264 lbs. Electric Start
Tongue Weight90 lbs. (Transport) 112 lbs. (Lowest Position)
Shipping Weight310 lbs. Manual Start, 320 lbs. Electric Start

Related product manuals