Dräger 8000 NC - Page 19

Operation
Wait for warming-up time.
Wait for about 35 minutes before use.
• Heat incubator in "air temperature control" operating
mode.
If incubator has to be used urgently:
• Operate incubator in standby mode:
Set air temperature to 32 °C to 36 °C,
see p. 20, and set humidity control to 0, see p. 30.
Just before placing the baby in the incubator:
Fill water container
• If required use protective gloves.
1 Take cover of water container off and
2 fill container to mark with clean, distilled or
demineralised water (hospital dispensary).
Do not use any additives.
Take care not to overfill.
• Put cover of water container back.
• Then disinfect hands.
If water bottles are used:
Fill water bottles
• If required use protective gloves.
1 Open back panel and fold down.
2 Disconnect empty water bottles and refill with 500
clean, distilled or demineralised water (hospital
dispensary). Do not use any additives.
• Refit filled water bottles and close back panel
again.
• Then disinfect hands.
Placing baby in the incubator
• Open front door and pull out bed.
• Put the baby on the bed and slide the bed back in
position.
• Close the front door and check that the catches are
properly engaged.
• Adjust the bed as required.
19