Dräger 8000 NC - Using Phototherapy Unit.33; Using Babylink Incubator Interface.33

Operation
Phototherapy
Interface
Using phototherapy unit 800/8000/4000
Accessory
Follow relevant Instructions for Use.
• Push trolley carrying phototherapy unit under incu¬
bator or in the case of Photo-Therapy 4000 can also
be placed directly on top of the canopy.
• Adjust height:
Minimum distance between bottom of phototherapy
unit and patient is:
0.4 m for Photo-Therapy 800/8000
0.3 m for Photo-Therapy 4000
If the height of the bed is changed later, make
sure that this minimum clearance is still
maintained.
• Follow safety advice, see p.18.
Exampel: Photo-Therapy 4000
Using "BabyLink Incubator" interface
(optional)
The "Babylink Incubator" interface provides incubator
data (actual values, set values, alarms) via a serial
interface.
At present, measured values can be displayed as trends
on the Drager Babyguard 8000 Paediatric Monitor.
Other possible connections are the Drager BabyScreen
or any Windows-PC which can run the ThermoView
program.
The interface protocol is included in the BabyLink
modification set (82 90 607).
Follow Instructions for Use for interface.
33