Dräger 8000 NC - Technical Data.47

Technical Data
Technical Data
Ambient conditions:
During operation
Temperature
Atmospheric pressure
Rel. humidity
During storage
Temperature
Atmospheric pressure
Rel. humidity
Operating data
Electrical power source
Heat output at 230 V
Air
Water heater
Current consumption at 230 V
20 °C to 30 °C
900 to 1100 hPa
15 to 95 %
0 °C to 70 °C
900 to 1100 hPa
15 to 95 %
220/230 to 240 V AC (as per order)
50/60 Hz (as per order)
400 W
100 W
2.5 A
Performance data
Warming-up time
Temperature drop (at room temperature of 25 °C
and temperature inside incubator of 36 °C)
Two hand ports opened
Front door opened
Humidification
Air speed over the bed
Single wall
Double wall
35 minutes from 20 °C to 31 °C (with or without humidification)
<1 °C
<5 °C
Evaporation of distilled or demineralised water
<15 cm/second
<8 cm/second
Fresh air flow 30 L/min
CO 2 flushing, according to IEC 601 -2-19/105.1
maximum CO 2 concentration inside incubator
Raising bed
Range of measured values
Air temperature
Skin temperature
Range of set values
Air temperature
Skin temperature
Humidity
0.2 %
at right or left, 8° angle of tilt on both sides
10 °C to 50 °C
30 °C to 42 °C
28 °C to 39 °C
35 °C to 37 °C
Depending on operating conditions, setting values from
1 to 10 gives a relative humidity inside the incubator from
about 30 to 85 %.
47